|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-15-2011, 06:37 PM
|
#3 |
|
Account Suspended
Join Date: Jul 2007
Location: Plumas Lake, Ca.
Posts: 1,009
|
Re: 350 block with 060 over bore
If the cylinders are round with no ridge at the top they should be able to be honed with no problems... Are they just bare blocks or do they have pistons, crank etc?
If complete, you basically would do a ring and bearing job and have a fresh motor although one that is at the end of its life. Its probably cheaper to buy a block now than to sleeve what you have. |
|
|
| Bookmarks |
| Tags |
| 060 overbore, 350, hone |
|
|
Threaded Mode