|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-15-2011, 04:24 PM
|
#1 |
|
Registered User
Join Date: Jan 2002
Location: Rhome, TX
Posts: 209
|
Full foam bench seatback
I am in the process of redoing my seat in my 68, I was planning to by new foam for the back and bottom. I have checked at a couple different websites and there seems to be some differences. My seat has a full foam bottom and a coil spring back, is this a correct combination? It looks like the later models (69-72) had a full foam back, could I use a full foam back on my seat, could someone send me a photo of a full foam back (may not be able to see much if it is covered up.)
Thanks
__________________
1968 C10 LWB 327 bored 40 over, RHS heads, KB pistons, Eagle rods, Edlebrock carb & intake 1968 C10 flatbed 307 w/ 4 spd manual (dads old ride) 1936 1/2 tn pickup, 400sb 350 turbo (partially restored) 1949 1/2 tn, needs complete restore (future project) 1969 Chevy impala 4 dr no post (wifes future car) 2010 GMC Serria 4x4 crew, leveling kit |
|
|
|
| Bookmarks |
|
|
Linear Mode
