Any one upgraded to 3/4 ton calipers? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BurnoutNova · 11-04-2011, 01:40 PM

I did a 3/4 ton swap on my 86 K10, the calipers bolted up fine, pads were fine. I used AN braided line for my hoses though, so I never had an issue with them being to short. I haven't actually driven it more than around the block yet, but everything seems fine now.

The larger piston will give you a little more stopping power, but I think it's minimal. I didn't think the booster or master cylinder were different?

11-04-2011, 01:40 PM	#1
BurnoutNova Registered User Join Date: Mar 2004 Location: CA Posts: 2,057	Re: Any one upgraded to 3/4 ton calipers? I did a 3/4 ton swap on my 86 K10, the calipers bolted up fine, pads were fine. I used AN braided line for my hoses though, so I never had an issue with them being to short. I haven't actually driven it more than around the block yet, but everything seems fine now. The larger piston will give you a little more stopping power, but I think it's minimal. I didn't think the booster or master cylinder were different?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.