Hood Emblem Dimple locations

[coralhead]

Can anyone provide me the approx location dimensions of the Hood emblem dimples shown below. (bad picture)

[mknittle]

I can check in the morning.

[coralhead]

Originally Posted by mknittle

I can check in the morning.

Thank you

[mknittle]

Originally Posted by coralhead

Thank you

I have to go to the doctor with my wife so I will measure one when I get back.

[mknittle]

the holes are an even distance apart. the way i measure holes that are the same diamater is from the near edge of one to the near edge of the other.
all my vertical measurements are from the center of the hole to the bottom edge of the hood with the tape held close to the comtour of the hood.
The middle 2 holes are about 1/8" higher.I held a striaght edge across the top edge of the end holes and that is the center of the inside holes. the dimples average 1/8 deep. let me know if you have any questions.



Mark

[coralhead]

Thanks for the numbers...... That is a nice finish on the hood, looks quite natural.

Hope your Rx appointments went well.

[mknittle]

Originally Posted by coralhead

Thanks for the numbers...... That is a nice finish on the hood, looks quite natural.

Hope your Rx appointments went well.

The finish is called mossy winter.
just a check on my wife's new insulin pump. all is well for her. it's harder on me though, she feels so good I can't keep up with her, man it's all go go go do do do! LOL