|
11-27-2011, 10:12 PM
|
#1 |
|
Registered User
Join Date: Mar 2011
Location: Pearland, TX
Posts: 70
|
trim moulding?
I have a 71 c10 that i bought a few weeks ago now. The fenders have the moulding on top and bottom but the doors dont have spots for the moulding. This is my first c10 so how hard is it to add moulding to the doors or would it be easier to try and find doors with the moulding already?
Thanks |
|
|
|
11-27-2011, 10:23 PM
|
#2 |
|
Registered User
Join Date: Aug 2010
Location: San Diego, CA
Posts: 128
|
Re: trim moulding?
The upper molding is easy to install on the doors, but the lower door molding can be hard unless the doors are off. My '71 has the factory holes for the lower trim a little less than 1" in from the edge of both the front and back of the door. The front attachment clip on the lower door molding that goes through the front hole needs a nut on the back side. This nut goes on behind the lower door hinge, it is very hard to get to unless the door is off or the front fender is not yet installed.
|
|
|
|
|
11-27-2011, 10:32 PM
|
#3 |
|
Carpe manana
  
Join Date: Dec 2010
Location: Eau Claire, WI
Posts: 12,351
|
Re: trim moulding?
You can use barrel nuts to install trim in the hard to reach places. NAPA part # 665-1457
__________________
1972 K5 CST Highlander Blazer: http://67-72chevytrucks.com/vboard/s...d.php?t=708547 1972 K20 Cheyenne Super: http://67-72chevytrucks.com/vboard/s...d.php?t=528308  Members met: ORANGBLAZ, 2003 silverado, MikeCofield, BB72CHEVKT, Duncan&Son, Sameyrasmea72, THENEWMEXICAN, HotRod C/10, brianthelion02, Sport/Truck, ryanroo, michael bustamante, Dirt's72, Already Gone, WestButteTruck, 57taskforce, Moreyel, painterljp, AASmedic, SoCoC10, Lumaestas, carbuff382, Chevyland
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
