Build #2 Crusader! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

yousesteers · 12-08-2011, 10:02 PM

Man I wish I had taken pictures when i put my seats in I lowered the floorboards 3 inches. I basically took the raised part on each side out and made them even with the small ridge that runs from the transmission tunnel to the raised area. I cut mine on the front and 2 sides then pushed them down and pulled and bent everything to meet up and then welded it all together I mounted the seats on a piece of 4 in flat metal and then bolted that to the floors . My seats were out of a 2005 Silverado. There are a couple of not very good pictures of the seats installed in the truck.

12-08-2011, 10:02 PM	#10
yousesteers Registered User Join Date: Nov 2011 Location: Paris, MO Posts: 290	Re: Build #2 Crusader! Man I wish I had taken pictures when i put my seats in I lowered the floorboards 3 inches. I basically took the raised part on each side out and made them even with the small ridge that runs from the transmission tunnel to the raised area. I cut mine on the front and 2 sides then pushed them down and pulled and bent everything to meet up and then welded it all together I mounted the seats on a piece of 4 in flat metal and then bolted that to the floors . My seats were out of a 2005 Silverado. There are a couple of not very good pictures of the seats installed in the truck. __________________ Clint Youse Paris, MO 1984 Chevrolet 3+3 K30 with Cummins 1966 IH Scout has been a work in progress for 16 yrs



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.