|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-25-2012, 12:16 AM
|
#1 |
|
Registered User
Join Date: Oct 2011
Location: Richmond, TX
Posts: 26
|
Rust repair on '65 C10
Got to replace cab supports, footwells, inner and outer rocker panels, and partial floor pan. Wondering what order I should go so that I don't duplicate too much effort. Any advice on techniques would be helpfull, I have the normal tools; spotwell cutter, mig, cutoff wheels, air hammer, etc. Thanks
PS, cab is resting on its back. |
|
|
|
01-25-2012, 01:04 AM
|
#2 |
|
Registered User
Join Date: Jan 2012
Location: Chula Vista, CA
Posts: 109
|
Re: Rust repair on '65 C10
Welcome to the forum from San Diego. Sorry I cant help with your question . But maybe being back to the top will help
__________________
Why can't I find it until the last place looked? 65 Longbed 283 three on the tree. 66 Longbed 292 three on the tree.Pennys A/C Trucks made in USA Buy a much as you can, Made in the USA |
|
|
|
|
01-25-2012, 08:52 AM
|
#3 |
|
Registered User
Join Date: Nov 2011
Location: Omaha, Nebraska
Posts: 437
|
Re: Rust repair on '65 C10
(You might benefit from posting this over in the paint and body section...)
That being said, I'm in the same place as you are except my cab is still on the frame. So far I've replaced a fair amount of the toe section of the floor. I have the sheet metal cut out over the top of the front drivers side cab mount so I think I'll tackle it next. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
