BDS 6" lift

[maskale]

Originally Posted by 76stepsidechevy

Its only a single cardon shaft in the rear and the transfer case isn't dropped, I was taught with a single cardon you needed to have both angles the same or it would vibrate. The angle doesn't look all the great but I think more shim would just make it worse. I have a pile of shims left over from experimenting with my jeeps rear cv shaft I just hate to be taking my truck apart until I get it right in this weather.

So u know the angles need to be the same, and u admit the angles dont look great. So why ask? Go fix it.

Dont stack ur shims.



If ur angles are good then ur problem is somewhere else.

For checking for vibration its best to run a known set of good smooth hwy tires. An old set of 44" boggers wont tell u much about ur drive line.