|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-03-2009, 04:40 PM
|
#1 |
|
An American Soldier
 
Join Date: Feb 2005
Location: Grumolo D' Abadessee, Italy
Posts: 503
|
Need Measurements for Installing Fender Emblems
I want to install 67 "10" emblems on my repop fenders. I need to know the measurements for the two holes closest to the door. I can figure out the other two from there.
Since the One and Zero are different sizes, I am assuming the holes are different on the driver and passenger side. Can someone please confim for me if you have an old fender laying around. Here are the measurements I want:  Thanks,
__________________
Dan dan.brue@us.army.mil Last edited by 4tiresngas; 09-03-2009 at 05:29 PM. Reason: typo |
|
|
|
02-10-2012, 12:11 AM
|
#2 |
|
Registered User
Join Date: Feb 2010
Location: louisiana
Posts: 130
|
Re: Need Measurements for Installing Fender Emblems
Old thread but I was wondering if anyone knows the placement of these fender badges.
|
|
|
|
|
02-10-2012, 09:31 PM
|
#3 |
|
Registered User
Join Date: Nov 2009
Location: GA/AL
Posts: 290
|
Re: Need Measurements for Installing Fender Emblems
I need these mesurements also for my new fenders
__________________
1965 c10 short stepside  (dad's project)1967 c10 fleetside 350/350 trans (my baby) |
|
|
|
|
02-12-2012, 02:43 PM
|
#4 |
|
Registered User
Join Date: Jul 2006
Location: El Cajon Ca
Posts: 84
|
Re: Need Measurements for Installing Fender Emblems
Hope these give you the info that you need.
|
|
|
|
|
02-14-2012, 11:58 PM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: louisiana
Posts: 130
|
Re: Need Measurements for Installing Fender Emblems
I am not sure but this doesn't look like it helps with the c-10 emblems. I see where it says existing hole but really no other reference points. Maybe someone could help.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
