CO a few parts

[454stepside]

crank pully cast with extra pully for power steering 45.00

hood hinges all work good not loose 40.00 per set ---- 3 sets

charcole canister good brackets tops of canisters are broke 15.00 each ---2

67 e brake handle 45.00

67-70 outer front bumper brackets 25.00

rear slider for parts missing latch let me know if you need any parts from it

shipping not included

money orders only

[454stepside]

few more

[454stepside]

ttt

[454stepside]

ttt

[454stepside]

anyone need anything

[454stepside]

new prices

[454stepside]

ttt

[byates2]

would you have the ignition parts for a 67, i need the spacer for the ignition switch

[454stepside]

ttt

[kellytheaker]

i could use a piece for the rear slider , the drivers side slider seal portion the opposite end of the latch , i could use that bar , and the top and bottom seal could use some attention and im not sure you can get it out or if new window track for the door would work . Maybe yours will be better and remove intact

[454stepside]

Originally Posted by kellytheaker

i could use a piece for the rear slider , the drivers side slider seal portion the opposite end of the latch , i could use that bar , and the top and bottom seal could use some attention and im not sure you can get it out or if new window track for the door would work . Maybe yours will be better and remove intact

do you have a picture of the peice you need i am sure i have what you are looking for just want to be sure

[kellytheaker]

Sorry - no picture , the piece needed is the aluminum piece on the sliding portion of the rear window opposite the latch - i will check but i believe it is the drivers side . the aluminum finish /bar . and i could use the glass channel top and bottom - you may not be able to remove intact - i may need to find the correct stuff - door glass run may work

[454stepside]

Originally Posted by kellytheaker

Sorry - no picture , the piece needed is the aluminum piece on the sliding portion of the rear window opposite the latch - i will check but i believe it is the drivers side . the aluminum finish /bar . and i could use the glass channel top and bottom - you may not be able to remove intact - i may need to find the correct stuff - door glass run may work

ok i will look today for you Thanks Randy

[kellytheaker]

thanks Randy - i was at the shop and walked around for a bit and forgot to check -side - i will let you know in the morning - sorry to slow you up ! the pic shows you have both sides - so i know im covered with your parts . and please check for usable felt chanell mine is toast

[454stepside]

Originally Posted by kellytheaker

thanks Randy - i was at the shop and walked around for a bit and forgot to check -side - i will let you know in the morning - sorry to slow you up ! the pic shows you have both sides - so i know im covered with your parts . and please check for usable felt chanell mine is toast

kelly sorry i didn't have a chance to even look at it today but i will tomorrow for you sorry Thanks Randy

[kellytheaker]

that fine - it is the pass side outer - the one with the pull - i suspect both outers are the same , take a look . and the window track fuzzy any good ? thanks - please email - kellytheaker@hotmail.com im not getting updates or use PM