|
04-07-2012, 01:00 AM
|
#1 |
|
Registered User
Join Date: Mar 2012
Location: fullerton, ca
Posts: 26
|
Mid Length Headers
Does anyone know of any mid length headers that will fit my 74 stepside with a 350? The Headman long tube headers that are on it are dented up from dragging on my lowered truck. I would rather use mid length than block hugging shortys. I read somewhere on here the camaro headers would work??? Thanks.
|
|
|
|
04-07-2012, 01:25 AM
|
#2 |
|
At the body shop.
Join Date: Aug 2009
Location: Land of fruits and nuts.
Posts: 5,229
|
Re: Mid Length Headers
These fit on my 73.
http://m.summitracing.com/parts/PTE-H8021-1 Have these on it now do not hang below the frame. http://m.summitracing.com/parts/DOU-D310 Posted via Mobile Device
__________________
" That didnt make it any newer " " Dont antique the equipment " Last edited by KQQL IT; 04-07-2012 at 01:34 AM. Reason: a.d.d |
|
|
|
|
04-07-2012, 11:22 AM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,995
|
Re: Mid Length Headers
2nd Gen Camaro or Chevelle 3/4 length headers work on these trucks.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
04-08-2012, 12:07 AM
|
#4 |
|
Registered User
Join Date: Mar 2012
Location: fullerton, ca
Posts: 26
|
Re: Mid Length Headers
Thanks KQQL IT and SCOTI, I will check those out. I have had the 3 bolt flange collector type and have had problems with the gaskets blowing out. I thought the ball type flange would seal better.
|
|
|
|
|
04-08-2012, 01:55 AM
|
#5 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,995
|
Re: Mid Length Headers
Quote:
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
