|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-23-2012, 07:26 PM
|
#1 |
|
Registered User
Join Date: Mar 2012
Location: brandon, MS
Posts: 32
|
shift linkage question
Ok guys, I have a 72 blazer. I am having trouble with the shift rod were it mets up at the column. It goes down though all of the gears fine however, when I try to pull it back up into park, the rod slips down and does not come all the way back up into park. I tightend the bolt up on the back side and it is still slipping. Any thoughts?
|
|
|
|
04-24-2012, 10:09 PM
|
#2 |
|
Registered User
Join Date: Mar 2012
Location: brandon, MS
Posts: 32
|
Re: shift linkage question
Sorry don't know how to take this post off. I figured it out.
|
|
|
|
|
04-27-2012, 11:38 PM
|
#3 |
|
Registered User
Join Date: Nov 2009
Location: Mesa AZ
Posts: 30
|
Re: shift linkage question
No need to remove the post but maybe post the solution to the problem to help someone else down the road maybe =-)
|
|
|
|
|
04-29-2012, 01:20 AM
|
#4 |
|
Registered User
Join Date: Mar 2012
Location: brandon, MS
Posts: 32
|
Re: shift linkage question
No problem. I didn't have the gap washer? lined up correctly. The one that tightens up to the shaft was turned around backwards. It wasn't not getting tight up against the shaft. I know that seems very simple but after working on this thing all day I start to go a little crazy sometimes.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
