|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-29-2012, 12:09 AM
|
#1 |
|
Registered User
Join Date: Aug 2006
Location: Redmond, WA
Posts: 6,332
|
How to remove caliper boot?
I'm about to rebuild a set of '72 3/4-ton front brake calipers, and I've got the piston out but the whole setup is a little different than what I'm accustomed to.
How do you get the piston "dust boot" off? I don't mean the square cut seal, I mean the boot that protects it from dust and moisture. Normally I've seen there's a "boot ring" around the outside that holds it on, but in this case it looks like it's pressed in with a metal ring. But since I don't know for sure, I don't want to start driving out unrepairable pieces of my caliper! Thanks, Dave
__________________
1970 GMC Sierra Grande Custom Camper - Built, not Bought 1969 Pontiac 2+2 427/390 4-speed Coupe 1969 Pontiac 2+2 427/390 4-speed Convertible |
|
|
|
04-29-2012, 05:56 AM
|
#2 |
|
~Rest In Peace~
Join Date: May 2005
Location: CALIFORNIA NOR CAL
Posts: 9,707
|
Re: How to remove caliper boot?
its been a while since i did one but if i remember i use a pick and pulled them out
__________________
is it fast ? it has a lighting bolt donut? B___H please, I can remove 90% of your so called "beauty" with a kleenex |
|
|
|
|
04-29-2012, 09:00 PM
|
#3 |
|
Registered User
Join Date: Aug 2009
Location: St. Paul MN.
Posts: 1,996
|
Re: How to remove caliper boot?
Some calipers I have rebuilt the dust boot pounds in like a normal seal. First make sure you can get the dust boots then take a look at them should be straightforward
__________________
Fuzzy |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
