Potential Build, Destroked Aluminum 5.3 to 4.8, IR Intake, 8500 RPM

[69trk]

Originally Posted by theastronaut

Thanks, I signed up there earlier and made an introduction post but haven't had and replies yet. I kinda saw what you're sayin about the place, they don't seem overly friendly over there. I was planning on running afternarket forged rods, unless the stock ones could be beefed up? I read that LS6 Z06 engines had lightweight hollow valves that would be good for high rpm's. I think GM discontinued them though.
Posted via Mobile Device

I signed up over there also and have had no replys on my introduction... I don't think they like old school trucks.... Good luck on your build!!!

[theastronaut]

Originally Posted by 69trk

I signed up over there also and have had no replys on my introduction... I don't think they like old school trucks.... Good luck on your build!!!

They said to let them know what you're into, so I said 64-66 Chevy trucks and early VW bugs, and posted a couple pics of the VW. They prolly didn't like the VW.
Posted via Mobile Device

[BR3W CITY]

Originally Posted by theastronaut

They said to let them know what you're into, so I said 64-66 Chevy trucks and early VW bugs, and posted a couple pics of the VW. They prolly didn't like the VW.
Posted via Mobile Device

Could have been worse, you could have said that over on Yellow Bullet