![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#10 |
Registered User
![]() Join Date: Jun 2006
Location: NC
Posts: 105
|
Re: Pulley alignment advice needed
I'm using my vise. When I took the back cover off, the end of the shaft
protruded just enough outside of the housing so I could set it on the back vise jaw. I used a socket on the flange end. I had marked it so I could see any movement. I cranked down on the vise pretty hard for it to move. Overall it went very well. This is a new water pump but the box says made in china. It looks pretty good but I don't know how it compares to the original. |
![]() |
![]() |
Bookmarks |
|
|