Quick Ratio pwr str box from ECE.. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Tom Vogel** · 06-30-2012, 08:12 PM

Anyone using one? I have one I bought a few years ago, it looks no different on the outside and bolted right up. My problem is, I can't seem to get anything to fit the high pressure OR the low pressure side of the box. The fitting that I have For the high pressure side says it is for 79 and earlier Saginaw boxes, but it seems a wee bit too big. I think the low pressure side is supposed to be 3/8" but that seems to be too small.
Any ideas???

Posted via Mobile Device

kevmac · 06-30-2012, 09:00 PM

18mm and 16mm x1.5 o ring. the later boxes usually use these. Please confirn this someone if you can but the 80's car boxes are these fittings so I'm guessing yours is too

06-30-2012, 08:12 PM	#1
Tom Vogel 2WD Jimmy Join Date: Mar 2005 Location: Davis County, Utah Posts: 2,564	Quick Ratio pwr str box from ECE.. Anyone using one? I have one I bought a few years ago, it looks no different on the outside and bolted right up. My problem is, I can't seem to get anything to fit the high pressure OR the low pressure side of the box. The fitting that I have For the high pressure side says it is for 79 and earlier Saginaw boxes, but it seems a wee bit too big. I think the low pressure side is supposed to be 3/8" but that seems to be too small. Any ideas??? Posted via Mobile Device Last edited by Tom Vogel; 07-01-2012 at 09:32 AM. Reason: spell

06-30-2012, 09:00 PM	#2
kevmac Registered User Join Date: Jun 2012 Location: ft worth tx Posts: 135	Re: Quick Ratio pwr str box from ECE.. 18mm and 16mm x1.5 o ring. the later boxes usually use these. Please confirn this someone if you can but the 80's car boxes are these fittings so I'm guessing yours is too



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.