porterbuilt hood hinge question.

[cflvulcan]

Not sure if this is the correct section to put this under. I wana buy a set of nates 67-72 hood hinges. My question is, will they work on a cowl hood? I know they'll go on just fine but when the hood is open, will the scoop hit the cowl panel or wipers?
Posted via Mobile Device

[PBFAB.COM]

Originally Posted by cflvulcan

Not sure if this is the correct section to put this under. I wana buy a set of nates 67-72 hood hinges. My question is, will they work on a cowl hood? I know they'll go on just fine but when the hood is open, will the scoop hit the cowl panel or wipers?
Posted via Mobile Device

It will depend on how tall of a cowl hood you have. We have installed them on a 2" cowl hood and the scoop to the cab's cowl panel was close but it cleared.

It would fit with a larger cowl hood if you were willing to do a little trimming/clearancing on the hood's scoop.

Nate

[cflvulcan]

Thanks for the response nate. I got a 2" inch cowl hood and goes about an inch and a halfback from the rear of the hood. Just had a kid, money is tight. So I've been recycling cans and bottles and selling random c10 parts I got laying around. Ill be ordering them sometime this week. Hopefully if I keep going the way im going I can afford a dropmember soon too hahha. Have a good one.
Posted via Mobile Device