|
07-22-2012, 11:56 AM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Asheboro nc
Posts: 24
|
power stering on a 67
I have a 67 frame i am going to put power stering on it but to install the gear box I am going to have to cut the frame or space it out and I was wondering which way would be the best
|
|
|
|
07-22-2012, 12:09 PM
|
#2 |
|
Registered User
Join Date: Dec 2009
Location: Atlanta, Ga.
Posts: 1,050
|
Re: power stering on a 67
I have a early 68 which is the same frame as yours. Used a torch and heated it and made a divot with a hammer to clear the sector.
Tried using shims and didn't like the way it drove, "real twitchy".
__________________
I don't think we get smarter as we get older. We just run out of Stupid things to do. |
|
|
|
|
07-22-2012, 04:11 PM
|
#3 |
|
Senior Member
 
Join Date: Oct 2009
Location: Greensboro, NC
Posts: 698
|
Re: power stering on a 67
x2.
It really doesn't take much to dimple it. Like Chop said, I didn't like the way it felt either with spacers.
__________________
 1967 Chevy C-10, 250 L6, Powerglide, 3.73, SWB, FleetsideUpgrades: Power steering, Offset air cleaner, Rear Sport bumper, 3 point safety belts, HEI, -1/-2 springs, 16x5 wheels, McGaughy's disc brake conversion, Sway bar |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
