"Made Bail"

[smartass12]

Originally Posted by smartass12

rustspot (if u have the time) could you take three measurements for me. rear tire width, distance from outside rear tire edge to outside rear tire edge, and distance from inside rear tire edge to inside rear tire edge. Reason i need these measurements are i dont think my rear suspension setup is the same as your and i need to see if i can lay frame (with your rear end/wheel setup) without any binding/rubbing on the rear suspension components. Thanks again in advance if you are able to find the time.

The truck is coming along great..Frame looks like you can eat off it.. Thanks again for getting me the above measurements, at your leisure ( i know you have a ton of stuff on your plate)

[rustSpot]

Originally Posted by smartass12

The truck is coming along great..Frame looks like you can eat off it.. Thanks again for getting me the above measurements, at your leisure ( i know you have a ton of stuff on your plate)

Man I can't believe I did it but I go home and realized I left the written down measurements at the shop. Send them tomorrow. Sorry. Did get them tho!
Posted via Mobile Device
Posted via Mobile Device

[Jimbabwe]

Lookin' good!

[smartass12]

Originally Posted by rustSpot

Man I can't believe I did it but I go home and realized I left the written down measurements at the shop. Send them tomorrow. Sorry. Did get them tho!
Posted via Mobile Device
Posted via Mobile Device

No worries..I just hope i dont have to go a different route. Im sure ill know once i get the measurements...Also ,if you can recall, with your bed on did you have any room to go wider on your rear and still lay frame. The s10 rear wont work for me (will hit upper bag mounts) i feel like im trying to put a square block in a round hole...