|
10-06-2003, 01:54 AM
|
#1 |
|
tommy . master of madness
Join Date: Aug 2003
Location: Brilliant Ohio My own personal Hell!
Posts: 139
|
rotor ?
 ok heres the gig,,, i'm puting that 87 cross and susp. in my 67 BUT that will give me 5 bolt front and 6 rear. can i put 6 bolt rotors up front or will i need to do a spindel swap. HELP I'M THINKING TOO MUCH!!!!  TOM
|
|
|
|
10-06-2003, 09:01 AM
|
#2 |
|
Firefighter
Join Date: Feb 2001
Location: Yellville, Ar, USA
Posts: 1,943
|
Probably a spindle swap would be the best, altough I have seen in a magazine somewhere where they installed oversized or undersized (I can't remember which) bearings. But to me the spindle swap sounds a little safer.
__________________
'72 Chevy SWB 350 Auto '67 GMC LWB 350 4 speed '70 Chevy 4x4 Stepside 350 Auto Yellville, Ar. USA  
|
|
|
|
|
10-06-2003, 09:04 AM
|
#3 |
|
Firefighter
Join Date: Feb 2001
Location: Yellville, Ar, USA
Posts: 1,943
|
Or you could have them redrilled with the 6 bolt pattern, or have your rearend axles redrilled to the 5 bolt pattern.
__________________
'72 Chevy SWB 350 Auto '67 GMC LWB 350 4 speed '70 Chevy 4x4 Stepside 350 Auto Yellville, Ar. USA
|
|
|
|
|
10-07-2003, 11:17 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
I am pretty sure GMC Paul sells 6 lug rotors.
|
|
|
|
|
10-07-2003, 11:32 PM
|
#5 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
If you have the heavy(1.250 thick ) rotors, you can bolt on the aftermarket 6 lug rotors. Check with GMC paul, as Andy has suggested. Good luck,crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
