|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-15-2012, 08:07 PM
|
#1 |
|
Registered User
Join Date: Feb 2012
Location: Big Valley. Alberta
Posts: 674
|
Removable center in floorpan on 4x4 trucks
I was checking out some of my parts trucks last night and noticed that on the 80,82,84 & 85 they all have the removable center section in the floorpan. It's the same on the standard and auto 4x4 trucks,but the 87 4x4 standard is not removable.Can anyone tell me why this is?? TIA
Posted via Mobile Device
__________________
1977 Chev C30 454/465/14ff DRW 1974 Chev C20.350/465/14ff " Rock n Roll ain't noise pollution" 
|
|
|
|
08-15-2012, 08:43 PM
|
#2 |
|
Registered User
Join Date: Dec 2009
Location: Gap PA
Posts: 280
|
Re: Removable center in floorpan on 4x4 trucks
My '88 Blazer is the same way... which meant notching the floor to drop the SM465 out...
 I guess spot welds were a bit cheaper than bolts? Lucky me I saved the removable trans tunnel from my '80 Blazer!
__________________
1991 Mustang GT Vert, T-5 w/ Pro 5.0, Trick Flow upper & lower, BBK cold air intake, 3:73, BAMA chip, etc. 1988 K5 Blazer, [coming soon] TBI 400, SM465/NP208, 12 bolt rear, 3:08's, looks like a 1980. 1998 Jeep Grand Cherokee 4.0 fully loaded daily driver! Where there's a will, there's a rig! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
