|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-26-2012, 02:05 PM
|
#1 |
|
Registered User
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,294
|
Straight axle and spindle orientation
sorry for the stupid question but is there a particular orientation for how the spindles mount on the axle on my 57?
When I removed them (the spindles) I marked them L/R (my OCD) but when I look at the spindle itself, there doesn't seem to be a specific way they mount...
__________________
Once a Marine, always a Marine! My (Her) 57 Build "Beverly" My 66 Build "Betty" My 85 C10 "Old Blue" Help Me Find "Old Blue" OLD BLUE PART II Last edited by LDO; 09-26-2012 at 02:13 PM. |
|
|
|
09-26-2012, 03:40 PM
|
#2 |
|
Hollister Road Co.
Join Date: Apr 2005
Location: Houston
Posts: 6,134
|
Re: Straight axle and spindle orientation
On the spindle there is a slot in the threaded end, that slot faces up.
This spindle is facing upward. Although is looks like it pointing downward the axle is tilted to compensate and it will look level once installed. The bearing and shims goes under the axle and above the lower spindle pin hole. The spindle will fit left or right. |
|
|
|
|
09-26-2012, 05:21 PM
|
#3 |
|
Registered User
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,294
|
Re: Straight axle and spindle orientation
thank you sir!
__________________
Once a Marine, always a Marine! My (Her) 57 Build "Beverly" My 66 Build "Betty" My 85 C10 "Old Blue" Help Me Find "Old Blue" OLD BLUE PART II |
|
|
|
|
09-26-2012, 05:24 PM
|
#4 |
|
Registered User
Join Date: Jan 2012
Location: St. Petersburg, FL
Posts: 104
|
Re: Straight axle and spindle orientation
Yeah the spindle should be point towards the ground when installed. I am in the same boat as you LDO. My poor truck has been on jack stands for 2 weeks and the weather is finally tolerable!
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
