|
10-14-2012, 11:58 AM
|
#1 |
|
Registered User
Join Date: Oct 2011
Location: St.Andrews,Manitoba, Canada
Posts: 276
|
front end
Has anyone taken the front clip off of a 91 chevy lately.. Is it alot of work !!!I would like to do some front end work and painting and with a bad back it might be easier with nothing there !!! Thanks
|
|
|
|
10-18-2012, 09:56 AM
|
#2 |
|
Registered User
Join Date: Aug 2012
Location: Indiana
Posts: 470
|
Re: front end
bump
__________________
70 C10 working on a LSx swap  4.8L MS3 edelbrock pro flo intake, pacesetter long tubes, 4l60e 2500 stall hoping the tranny holds up lol |
|
|
|
|
10-18-2012, 04:02 PM
|
#3 |
|
Registered User
Join Date: Nov 2006
Location: pa.
Posts: 1,185
|
Re: front end
No it's not a lot of work and a lot easier than working around it. If bolt aren't rusty(HahahahA)u can have it off in an hour.
Posted via Mobile Device
__________________
67 chevy c 10 2x4 350/700r4 short/fleet 90 Chevy 1500 4x4 350/5 spd short/fleet 90 Chevy 454 ss 93 chevy camaro z28 auto t-tops 2013 Chevy Silverado LT CCSB 4x4 |
|
|
|
|
10-20-2012, 02:31 PM
|
#4 |
|
Registered User
Join Date: Jul 2012
Location: North Road, Alaska
Posts: 154
|
Re: front end
no its quite easy, i unbolt the inner fenders from the outer fenders, unbolt the 2 bolts in the doorjamb on each side, take the grille off, disconnect radiator, condenser, yadayada. then unbolt the 2 bolts on the bottom of rad support, they look like body mounts.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
