dana 44 knuckle compatability - The 1947 - Present Chevrolet & GMC Truck Message Board Network

75chev4x4 · 10-23-2012, 02:10 PM

Hey guys, I'm wanting to find out what knuckles will fit my Dana 44 on my 75 k20. The passenger side where the tie rod connects to the knuckle has been hogged out says my alignment guy. I guess the hole is bigger than it should be. So I am gonna get a new used knuckle for that side. What can I get this knuckle off, heard I can get one off a 10 bolt but not sure. I know I have to use an open knuckle because I believe that's what I have already. Just don't wanna buy the wrong part. Thanks

10-23-2012, 02:10 PM	#1
75chev4x4 Registered User Join Date: May 2012 Location: Estacada, Oregon Posts: 254	dana 44 knuckle compatability Hey guys, I'm wanting to find out what knuckles will fit my Dana 44 on my 75 k20. The passenger side where the tie rod connects to the knuckle has been hogged out says my alignment guy. I guess the hole is bigger than it should be. So I am gonna get a new used knuckle for that side. What can I get this knuckle off, heard I can get one off a 10 bolt but not sure. I know I have to use an open knuckle because I believe that's what I have already. Just don't wanna buy the wrong part. Thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.