What kind of pulley is this? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Lemield · 07-22-2010, 10:20 AM

I have never seen a crank pulley like I have on my truck. Can anyone tell me if this is stock or what??? Any help appreciated.

I am planning to put A/C on the truck (still deciding which kit to use).

vectorit · 07-22-2010, 10:24 AM

It's actually a two piece unit.
The one closest to the engine is stamped steel, and it's just a single groove model.
The one closest to the radiator is of cast iron, and from my experience has been added for AC or other stuff.

I have one just like it, but I have the two groove stamped steel pulley.

Lemield · 07-22-2010, 10:32 AM

Wow Vectorit....that was FAST! Thanks for the info. I'm guessing, based on your response that if I got a two groove stamped pulley to replace the single, I could then use the middle groove for an A/C compressor and then I could still use the bolt on inner groove for my PS pump.

63chevyll · 07-22-2010, 10:49 AM

man, im not good with the short water pump stuff

**kwmech** · 07-22-2010, 11:03 AM

I've got the same pulley on my 68 GMC with the 396. Aftermarket AC.

Sinister · 07-22-2010, 11:16 AM

I have that pulley on my factory AC truck with a 350 and PS. My water pump pulley has 3 grooves though.

48richard · 07-22-2010, 11:54 AM

I had the same set up, and when I put in AC I replaced the single groove pulley with a two groove, and put back the other two groove that I already had, so I had four grooves.
One closest to the block is alternator, then AC, then unused, and then PS

Lemield · 07-22-2010, 12:26 PM

Thanks everyone. You have all answered my question......again.....this board is a great resource.

71_ratrod_c20 · 12-19-2012, 01:29 PM

I have a 71 c20 and the stamped crank pulley is bent does anyone no where I can buy one from
Posted via Mobile Device

Lemield · 12-19-2012, 02:25 PM

Wow...this is an OLD thread....

That said, try board member Teeitup....Randy has a large inventory of parts for these trucks...great guy too.

71_ratrod_c20 · 12-19-2012, 02:29 PM

how do I go about contacting him
Posted via Mobile Device

Lemield · 12-19-2012, 02:33 PM

You can send him a private message...member name Teeitup....or you can search the parts forum for one of his parts threads...

71_ratrod_c20 · 12-19-2012, 02:35 PM

ok thx sir
Posted via Mobile Device

48richard · 12-19-2012, 06:48 PM

Are you looking for the single groove stamped pulley? I have one that I took off my engine.

bollybib · 12-19-2012, 09:01 PM

Old threads have a lot of good info in them. I like seeing them resurrected now and again.

07-22-2010, 10:20 AM	#1
Lemield Registered User Join Date: Dec 2004 Location: Arvada Colorado Posts: 1,321	What kind of pulley is this? I have never seen a crank pulley like I have on my truck. Can anyone tell me if this is stock or what??? Any help appreciated. I am planning to put A/C on the truck (still deciding which kit to use). Attached Images __________________ Larry 1949 Willys CJ2A, Kubota Turbo Diesel engine, Warn Overdrive, 11 inch brakes, 12volt, Warn M8000 Winch "Little Green" 1970 Rustoleum Roller Red C20 Custom Camper 454 TH400 "Big Red" 1971 K20 6.2 Turbo Diesel 4x4 4spd Ranger Overdrive "Pumpkin Wagon" 2005 VW Beetle Diesel 44+ MPG "Silver Bullet"

07-22-2010, 10:24 AM	#2
vectorit What? Join Date: Jun 2007 Location: Southern California Posts: 7,617	Re: What kind of pulley is this? It's actually a two piece unit. The one closest to the engine is stamped steel, and it's just a single groove model. The one closest to the radiator is of cast iron, and from my experience has been added for AC or other stuff. I have one just like it, but I have the two groove stamped steel pulley. __________________ Chris 1968 K20 Suburban 1972 K10 LWB PU

07-22-2010, 10:32 AM	#3
Lemield Registered User Join Date: Dec 2004 Location: Arvada Colorado Posts: 1,321	Re: What kind of pulley is this? Wow Vectorit....that was FAST! Thanks for the info. I'm guessing, based on your response that if I got a two groove stamped pulley to replace the single, I could then use the middle groove for an A/C compressor and then I could still use the bolt on inner groove for my PS pump. __________________ Larry 1949 Willys CJ2A, Kubota Turbo Diesel engine, Warn Overdrive, 11 inch brakes, 12volt, Warn M8000 Winch "Little Green" 1970 Rustoleum Roller Red C20 Custom Camper 454 TH400 "Big Red" 1971 K20 6.2 Turbo Diesel 4x4 4spd Ranger Overdrive "Pumpkin Wagon" 2005 VW Beetle Diesel 44+ MPG "Silver Bullet"

07-22-2010, 10:49 AM	#4
63chevyll gets board easy....... Join Date: Mar 2009 Location: Colorado Springs Posts: 717	Re: What kind of pulley is this? man, im not good with the short water pump stuff

07-22-2010, 11:03 AM	#5
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,630	Re: What kind of pulley is this? I've got the same pulley on my 68 GMC with the 396. Aftermarket AC.

07-22-2010, 11:16 AM	#6
Sinister Between Trucks... Join Date: Mar 2002 Location: Los Angeles, CA. Posts: 3,830	Re: What kind of pulley is this? I have that pulley on my factory AC truck with a 350 and PS. My water pump pulley has 3 grooves though. __________________ Beat it to fit, Paint it to match...

07-22-2010, 11:54 AM	#7
48richard Registered User Join Date: Oct 2009 Location: Phoenix, AZ Posts: 475	Re: What kind of pulley is this? I had the same set up, and when I put in AC I replaced the single groove pulley with a two groove, and put back the other two groove that I already had, so I had four grooves. One closest to the block is alternator, then AC, then unused, and then PS __________________ 1971 C10 Longbed, 350/TH350

07-22-2010, 12:26 PM	#8
Lemield Registered User Join Date: Dec 2004 Location: Arvada Colorado Posts: 1,321	Re: What kind of pulley is this? Thanks everyone. You have all answered my question......again.....this board is a great resource. __________________ Larry 1949 Willys CJ2A, Kubota Turbo Diesel engine, Warn Overdrive, 11 inch brakes, 12volt, Warn M8000 Winch "Little Green" 1970 Rustoleum Roller Red C20 Custom Camper 454 TH400 "Big Red" 1971 K20 6.2 Turbo Diesel 4x4 4spd Ranger Overdrive "Pumpkin Wagon" 2005 VW Beetle Diesel 44+ MPG "Silver Bullet"

12-19-2012, 01:29 PM	#9
71_ratrod_c20 Registered User Join Date: Dec 2012 Location: Huntington Indiana Posts: 3	Re: What kind of pulley is this? I have a 71 c20 and the stamped crank pulley is bent does anyone no where I can buy one from Posted via Mobile Device

12-19-2012, 02:25 PM	#10
Lemield Registered User Join Date: Dec 2004 Location: Arvada Colorado Posts: 1,321	Re: What kind of pulley is this? Wow...this is an OLD thread.... That said, try board member Teeitup....Randy has a large inventory of parts for these trucks...great guy too. __________________ Larry 1949 Willys CJ2A, Kubota Turbo Diesel engine, Warn Overdrive, 11 inch brakes, 12volt, Warn M8000 Winch "Little Green" 1970 Rustoleum Roller Red C20 Custom Camper 454 TH400 "Big Red" 1971 K20 6.2 Turbo Diesel 4x4 4spd Ranger Overdrive "Pumpkin Wagon" 2005 VW Beetle Diesel 44+ MPG "Silver Bullet"

12-19-2012, 02:29 PM	#11
71_ratrod_c20 Registered User Join Date: Dec 2012 Location: Huntington Indiana Posts: 3	Re: What kind of pulley is this? how do I go about contacting him Posted via Mobile Device

12-19-2012, 02:33 PM	#12
Lemield Registered User Join Date: Dec 2004 Location: Arvada Colorado Posts: 1,321	Re: What kind of pulley is this? You can send him a private message...member name Teeitup....or you can search the parts forum for one of his parts threads... __________________ Larry 1949 Willys CJ2A, Kubota Turbo Diesel engine, Warn Overdrive, 11 inch brakes, 12volt, Warn M8000 Winch "Little Green" 1970 Rustoleum Roller Red C20 Custom Camper 454 TH400 "Big Red" 1971 K20 6.2 Turbo Diesel 4x4 4spd Ranger Overdrive "Pumpkin Wagon" 2005 VW Beetle Diesel 44+ MPG "Silver Bullet"

12-19-2012, 02:35 PM	#13
71_ratrod_c20 Registered User Join Date: Dec 2012 Location: Huntington Indiana Posts: 3	Re: What kind of pulley is this? ok thx sir Posted via Mobile Device

12-19-2012, 06:48 PM	#14
48richard Registered User Join Date: Oct 2009 Location: Phoenix, AZ Posts: 475	Re: What kind of pulley is this? Are you looking for the single groove stamped pulley? I have one that I took off my engine. __________________ 1971 C10 Longbed, 350/TH350

12-19-2012, 09:01 PM	#15
bollybib Registered User Join Date: Nov 2010 Location: Carlsbad, CA Posts: 1,584	Re: What kind of pulley is this? Old threads have a lot of good info in them. I like seeing them resurrected now and again. __________________ - Jim - My Daily Driver is a 1969 Chevrolet Custom/20 Fleetside 350/TH400/Eaton H052 4.10 and its Project thread is here http://67-72chevytrucks.com/vboard/s...d.php?t=456911



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.