|
01-07-2013, 05:21 PM
|
#1 |
|
Registered User
Join Date: Jan 2013
Location: Swedesboro, NJ
Posts: 9
|
Linkage Help
Hello Everyone, my name is Frank, and I am new to this forum, and to Chevy Truck restoring. I have a 1950 Chevy Truck, came with no engine and I was able to find a good running 216 to put in it. The linkage rod from the gas pedal lines up with the throttle linkage on the Rochester 1bbl carb. The problem is when you push the gas pedal, the rod goes forward towards the radiator, but the carb linkage accelerates towards the firewall. So they are opposite. What Am I missing?? Any ideas would be greatly appreciated. Thanks.
|
|
|
|
01-07-2013, 07:49 PM
|
#2 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Linkage Help
I think there is a bell crank that bolts to the block that changes the front to back from the firewall linkage to a vertical for the carb. Someone with a AD factory manual can probably provide a drawing.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
01-07-2013, 07:56 PM
|
#3 |
|
Registered User
Join Date: Jun 2012
Location: wind lake WI
Posts: 1,747
|
Re: Linkage Help
welcome frank
__________________
LIL ERV the 50-3600 396 BBC stroked to 415 cid Richmond 6spd over drive C4 rear Porter built a arms Never give the Devil a ride,because he'll want to Drive! |
|
|
|
|
01-07-2013, 08:09 PM
|
#4 |
|
Registered User
Join Date: Sep 2012
Location: Oregon
Posts: 3,303
|
Re: Linkage Help
Welcome.
It should look like this  or close to it, some mounted on the exhaust manifold |
|
|
|
|
01-07-2013, 08:25 PM
|
#5 |
|
Registered User
Join Date: Jan 2013
Location: Swedesboro, NJ
Posts: 9
|
Re: Linkage Help
Thanks everyone,
It looks just like the picture Newfisher posted, yet the top of the assy accelerates towards the firewall, which doesn't make sense. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
