Re: Fusing the injector B+ wires ..?
I just did this last weekend and I soldered all four to the connector that goes to the fuse block, and I used the fuse block shown on lt1swap.com. I used an 80watt iron though, and didn't have a problem.
I'd have to look to be 100% sure but I have the pcm 12v constant on a fuse, pcm ignition switched 12v on a fuse, passenger and driver side injectors and coils on a fuse(4 fuses total), MAF on a fuse, fuel pump on a fuse and relay, and I think the transmission on a fuse. My block has 9 fuses right now and 3 relays. It wasn't that difficult, just draw it out on paper first and solder accordingly, because I didn't and had to redo some of the connections to fit my application.
|