1971 c10 stepside

[jmedero]

You get the correct 4 link bars yet? Lets see this bad boy as a roller!!
Posted via Mobile Device

[big_al_71]

Originally Posted by jmedero

You get the correct 4 link bars yet? Lets see this bad boy as a roller!!
Posted via Mobile Device

The second set of bars showed up ans they were the same ones he received the first time. He shipped all four back already called left messages and is waiting for a call back since yesterday. I was at Raul's house Saturday..

[PBFAB.COM]

Originally Posted by big_al_71

The second set of bars showed up ans they were the same ones he received the first time. He shipped all four back already called left messages and is waiting for a call back since yesterday. I was at Raul's house Saturday..

That sucks. No message on the voicemail from Raul... but we will give him a call back today.

Nate

[big_al_71]

video of raul's camaro

Silverstream 3 - YouTube

[raull]

Originally Posted by Grip

Originally Posted by raull
i could be wrong but something does not seem right to me , i installed the 4 bar link brakets where the instructions show , then the cnothc well opening centerline its suppossed to be 25.25 inches from the second bed mount hole , here's some pix , any thoughts, measurements or pix any body can share , thanks

My suggestion would be to take picture of how you measured the location of the notch. I hope this helps!
Posted via Mobile Device
Posted via Mobile Device

will do in a few , thanks !!!

Originally Posted by higXtech

Will this project have AC?
Posted via Mobile Device

yes it will have ac !!!!

[raull]

ok here we go , in the instructions it says for the step side to measure 25.25from behind the hole of the second bed mount to the center of the wheel line so here the pix

[raull]

now as for the four link bracket i went ahead and retaiped andstarted from the begining again i i did as the instructions said

[raull]

so i went ahead and i measure from the center of the bolt to the center line i i cameup with 26 inches

[raull]

now if you take the 3 1/2 inches fron the center of axle to about half thred on the joint as i show in the picture that would mean that i need a 22.5 bar like it was marked on the bars i got exept the actually measure 20 in , now i dont think i need to move the brackets 2 1/2 inches forward if i do so be it let me know Nate , thanks ,

[higXtech]

Originally Posted by raull

yes it will have ac !!!!

Awesome. I can't wait to see how you do the intercooler/wastegate/intake piping.