1971 c10 stepside

[PBFAB.COM]

Originally Posted by raull

thanks for the info and pix , im picking up my bed and starting all over , after all i may even have the wrong offset wheels to go even lower than it was with the ridetech

Let's do this...

Get the bed in place.

Confirm the wheel centerline measurements and make sure the notch is centered.

Make sure the notch depth is correct so that when the axle is bottomed out it sits right where you want it (this is very important due to the way the bag is set up. If you have excess room in the notch when deflated, the bag will not get the total amount of travel).

Bottom the axle out in the notch then get me a center to center measurement on the bushing centers for the four-link bars. I will make you a set to that dimension. That way you don't have to re-locate the front mounting bracket. This will eliminate any additional holes in the frame.

Nate