|
02-22-2013, 08:57 PM
|
#1 |
|
Registered User
Join Date: Apr 2012
Location: Henderson Nevada
Posts: 804
|
Recovering my seats
I want to recover my seats and have found the material to do it. How much material wil it take t do the job? I have been told 7 yards anyone know?
|
|
|
|
02-23-2013, 10:00 AM
|
#2 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,761
|
Re: Recovering my seats
Cant answer your question, since i only did my front seats. But, if you are using SMS, they should know.
The non expanded matrl. seems to match the grain better of the original seat, and make sure that you get the right matrl. for the seat back and bottom, as you can see the embossing is differant Also, on the top of the seat back, there are four places that the wire frame will rub through. I had mine ground down some, and extra padding put in that area. The seats are interchangable, right to left, so you can eliminate some of the wear on the drivers seat. Plus, these utilities are more comfortable... Good luck on your build, and post up lots of pics....
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
02-23-2013, 09:40 PM
|
#3 |
|
Registered User
Join Date: Apr 2012
Location: Henderson Nevada
Posts: 804
|
Re: Recovering my seats
Took my Blazer over to the upholstery guy today and he said to get 3 yards of the patern material and 4 yards of the plain material. I am going to purchase it from SMS.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
