|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-24-2013, 03:34 AM
|
#1 |
|
Registered User
Join Date: Feb 2013
Location: Alberta
Posts: 28
|
Cab floor sheet metal gauge?
Finding a ton of smaller rust through spots on my newly acquired 72' 1500.
Whats the oem gauge for the sheet metal in the floor, rockers, etc.? |
|
|
|
02-24-2013, 08:17 AM
|
#2 |
|
1969 Custom 30 wrecker
Join Date: Sep 2001
Location: Pottsville, Pa
Posts: 2,611
|
Re: Cab floor sheet metal gauge?
Should be 19 gauge. Replace with 18 or 19.
An old hood or panel to cut up is the best sheetmetal you will find. 
__________________
Bob 63 Impala 283/PG/3.36 (under restoration) 66 Impala 327/PG/3.36 66 Chevelle SS 409/M22/3.55 69 Chevelle 307/PG/3.08 (future restoration) 69 C10 short stepside 454/TH350/3.73 69 Custom 30 tow truck 350/4 spd/4.10 (resto done, CRUISIN TIME!) 71 Cheyenne 20 fleetside 350/4 spd/4.10 71 Chevelle 6/PG/3.08 72 Chevelle 454/M21/4.10 |
|
|
|
|
02-24-2013, 04:33 PM
|
#3 |
|
Registered User
Join Date: Feb 2013
Location: Alberta
Posts: 28
|
Re: Cab floor sheet metal gauge?
I got a set of used oem doors, might cut up the originals to get some steel outta them. Thanks!
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
