|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
02-28-2013, 10:10 PM
|
#1 |
|
Certified Car Nut
Join Date: Jan 2005
Location: Inglewood, California
Posts: 3,118
|
Re: What a mess just look at this.
Boss hawg,
I'm sure your install is not anywhere closed to what was under this truck.lol |
|
|
|
02-28-2013, 10:56 PM
|
#2 |
|
Registered User
Join Date: Feb 2013
Location: Heber Springs, Arkansas
Posts: 75
|
Re: What a mess just look at this.
No it isn't that bad! Lol... I don't know a whole lot about putting them in though. I read earlier in your thread you were talking about a protractor something(couldn't remeber what it was called) and making sure the angles were the same as the donor car. I didn't have a donor car and I tried to find as much info as I could on installing the factory c4 crossmember but found next to nothing on it. What I did was level the frame and notched it cause the crossmember was wider than the frame for the most part. After I got it placed where I wanted it I leveled the with the lower control arm..... I have no idea if this is anywhere close to being correct in anyway shape or form!
Posted via Mobile Device |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
