My '59 Apache

[_Ogre]

Originally Posted by Denee007

Ok, I'm going to have work on a name for the old truck, names just don't jump into my head for naming a truck,

if you use the same name format as i did your name/plate would be EENED
i tried to get my initials but KUJO was taken,
so was OGRE (a misspelling of my last name)

[Denee007]

Is that kind of like Pig latin?

Originally Posted by _Ogre

if you use the same name format as i did your name/plate would be EENED
i tried to get my initials but KUJO was taken,
so was OGRE (a misspelling of my last name)

Ok, yesterday I worked on my drivers side window install following Blackdiesels video~ testy but doable, and a big thanks to Clarance J for the part so necessary to get going on this part of the build! I guess after the completion of this drivers door, I'd like a guide channel for the channel nearest the door latch to be like the Wing channel guide. The wing channel guide is a narrower channel and the window felt of which the Brothers kit supplies, which makes a continous loop fits this channel perfectly, whereas the original channel that's un-spot welded, is very wide. I may look for a used wing to rob the channel from it for the passenger side. I hope that made some sense!lol
Here I'm using tie wraps to hold the guide felt/liner in place. If I'd roll down the window, it'd pull the liner down. Since this pic, I have used adhesive(actually black seam sealer from Braults auto paint~ recommended by the saleman there~ gave me a tube for a caulk gun) to hold the felt in place and allowed to cure overnight, should be re-installing the glass hopefully for the last time, then work on fine tuning.

Yes, there is glass in the door~ just can't see it!