2 inch rear drop on 71 c10

[noguirre71]

I went with 2.5" drop spindles along with 1"Cpp drop springs in the front and a 5" in the back I believe and I got a nice looking lower stance. The rear sits higher but nothin not too high compared to the front. I think it has a nice balance to it.
Posted via Mobile Device

[69gmcc10]

I got the u bolts from a local tractor supply shop, 3/4" dia rod 3 1/2" U and the longest bar they had, I think it was 10" or 11" long after it was bent. The blocks I made from 2"x2" 1/4" tubing (the holes are 7/8" s there is some room for misalignment.