harness recommendations

[mknittle]

Originally Posted by Daze57

roger55
headlight switch - i just rat filed the hole a bit bigger (carefully ) and the switch fit ok .
as far as the knob - i just got one of the set screw type like you were talkin about and loctite (the set screw) it on the shaft - so far no probs
i also loctite the ignition switch bezel and i have had no probs with that either . i also have tightened it up the best i can and so far so good ( so far) lol
also i do have a couple of OEM headlight switches if you decide you want to switch over.
(dont know if you have one or not )
i went to the AAW one only because it was there and new - the OEM switches i have are in great shape and prolly would be ok - but i just decided to use what AAW had.
hope some of this helped

If you use Loctite use the blue{serviceable}. if you use the red{permanent} you will get an over dose of fun trying to get it apart if necessary.