|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-03-2003, 01:58 PM
|
#1 |
|
Account Suspended
Join Date: Jun 2003
Posts: 139
|
snapped u bolts! how many lbs of torque for lower A arm u bolts?
replacing the u bolts that connect the a arms to the crossmember
I got to work today and noticed I was sagging a little - looked under the truck and noticed one of the bolts was snapped! and my a arm was only being held there by one u bolt. ( was on the freeway doing 80 just 5 minutes previously) scary! 
|
|
|
|
12-03-2003, 03:53 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
45 ft/lbs for a c10
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
12-03-2003, 11:07 PM
|
#3 |
|
Registered User
Join Date: Jul 2003
Location: So. Cal.
Posts: 389
|
I had snapped one a few months back too. I actually got some 9/16" ubolts from ECE. I installed those because I don't think it's possible to snap them. You just have to drill out the holes a little. I would recommend them if you have disc brakes too.
__________________
1968 Chev SWB with 1998 Corvette LS1 305hp and 320 ftlb to the wheels (stock engine!) AEM EMS and wideband O2 sensors Bowtie Overdrive's 700R4, stage 3 Baer 4 wheel discs and 20s http://iciclelanding.com/aperture?album=2049&view=album |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
