The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 08-28-2013, 04:29 PM   #1
kellydown
Registered User
 
Join Date: Mar 2013
Location: Lufkin, Tx
Posts: 13
1990 454 tbi Help

Somewhat new to the website, I have 1990 Chevy v3500 454 Tbi. My problem begin a couple months ago. Been thru a bunch of old threads but cant figure this one out. Here's how it went down....

1. Truck started hesitating and missing under throttle. Idles fine.
2. replaced Egr valve
3. ran fine for a few weeks, then it started doing the same thing.
4. replaced Map sensor
5. ran good for about a month then....see #1 & #3
6. Today I did the old paperclip trick on the OBD connection. It read code 12.
Drove it down to O'Reilly's today with it running like crap. They plugged
into and it showed no codes either
7. Now I am starting to pull out what little hair I have left.

It has dual tanks, it runs the same on either tank, so I would think that would rule out fuel pump issues. I just don't understand why I would replace something then run good for a few weeks then back to the same ole same ole.
Your help is much appreciated!
kellydown is offline   Reply With Quote
Old 08-28-2013, 05:03 PM   #2
bnoon
Registered User
 
Join Date: Jul 2012
Location: Des Moines IA
Posts: 1,250
Re: 1990 454 tbi Help

One thing I would check is the TPS voltage. Make sure it's nice and steady through the full gas pedal travel.

I would move to a wide band tester next to monitor a/f ratio to see if fuel is falling off or jumping up at the time of the stumble.
__________________
- 1981 Sierra 454, NV4500 swap
- 2006 Z06, 25k miles
- 1973 Nova - Project CarNova Virus on Youtube
bnoon is offline   Reply With Quote
Old 08-28-2013, 05:13 PM   #3
kellydown
Registered User
 
Join Date: Mar 2013
Location: Lufkin, Tx
Posts: 13
Re: 1990 454 tbi Help

Thanks, I will check it out and get back with ya'll
kellydown is offline   Reply With Quote
Old 08-28-2013, 05:25 PM   #4
BONUSCAB
Registered User
 
Join Date: Jan 2013
Location: east troy, WI
Posts: 341
Re: 1990 454 tbi Help

http://coloradok5.com/forums/showthread.php?t=309464
BONUSCAB is offline   Reply With Quote
Old 08-28-2013, 05:56 PM   #5
notallthere
Registered User
 
Join Date: Nov 2011
Location: sarnia ontario canada
Posts: 211
Re: 1990 454 tbi Help

How old is the fuel filter. I had an old truck and the fuel filter plugged. I ran through the same things as you to find out the filter was crap. Changed it and everything worked fine after that.
notallthere is offline   Reply With Quote
Old 08-28-2013, 06:33 PM   #6
rfmaster
Registered User
 
rfmaster's Avatar
 
Join Date: Oct 2003
Location: OC CA
Posts: 1,374
Re: 1990 454 tbi Help

Quote:
Originally Posted by kellydown View Post
Somewhat new to the website, I have 1990 Chevy v3500 454 Tbi. My problem begin a couple months ago. Been thru a bunch of old threads but cant figure this one out. Here's how it went down....

1. Truck started hesitating and missing under throttle. Idles fine.
2. replaced Egr valve
3. ran fine for a few weeks, then it started doing the same thing.
4. replaced Map sensor
5. ran good for about a month then....see #1 & #3
6. Today I did the old paperclip trick on the OBD connection. It read code 12.
Drove it down to O'Reilly's today with it running like crap. They plugged
into and it showed no codes either
7. Now I am starting to pull out what little hair I have left.

It has dual tanks, it runs the same on either tank, so I would think that would rule out fuel pump issues. I just don't understand why I would replace something then run good for a few weeks then back to the same ole same ole.
Your help is much appreciated!
90 percent of the time when owners report missing under throttle, runs fine at idle indicates low fuel pressure. TBI system fuel pressure spec is between 9 to 13 PSI at the inlet to the TB. Get a fuel pressure gauge and TBI adapter and measure fuel pressure. I've seen TBI to run with 6PSI, but very poorly. The 454 drinks a lot of fuel when when it moves a heavy truck, while at idle only internal friction, and external loads need to be overcomed to keep engine idling. Measure FP first before tossing anymore new parts at it.

Fuel pumps usually are not a problem (but they do wear-out fast), but the fuel hose that connects outlet port to a fuel feed through turns soft and leaks after 23 years of service. Today's gas formulations contain ethanol (E10) which is unfriendly to older rubber compounds. If you end up replacing FPump and hoses make sure to replace the hose with SAE30R10 rated hose - Gates or Good Year make fuel submersible fuel hose.

//RF
__________________
"The Beast"

1975 Chevrolet C20 longbed
350/700R4! with 3inch body lift
Dual Flowmasters Super 40's!
TBI retrofit completed (2007-07-29)
New 383CID (+030) 08-304-8 9.5:1CR x36,005 (2012-12-17)
rfmaster is offline   Reply With Quote
Old 08-28-2013, 07:23 PM   #7
kellydown
Registered User
 
Join Date: Mar 2013
Location: Lufkin, Tx
Posts: 13
Re: 1990 454 tbi Help

Thanks so much for your help guys, all this is new to me. Been working on and racing dirt bikes most of my life (old age shut that down) and just plain don't know anything about these things. I have figure out how to check the TPS voltage and checking the fuel pressure. Just bought a Chiltons online repair manual to help me locate these things. Going to the auto parts store again here in a bit to get a filter and a fuel pressure guage.
kellydown is offline   Reply With Quote
Old 08-29-2013, 01:15 AM   #8
SCOTI
Registered User
 
SCOTI's Avatar
 
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
Re: 1990 454 tbi Help

Fuel filter.
Fuel pump psi validation.
O2 sensor functioning correctly?
Temp sensors functioning correctly?
Posted via Mobile Device
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.
SCOTI is offline   Reply With Quote
Old 08-29-2013, 06:28 AM   #9
BigBlocksRule
Registered User
 
Join Date: Jun 2008
Location: Lubbock, TX
Posts: 2,047
Re: 1990 454 tbi Help

Not to dis this site at all, but the best site for your truck is the 454SS website - they've been working with your identical system for years, should have all the answers.
BigBlocksRule is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:25 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com