Valve covers - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**bigmac73** · 09-28-2013, 09:17 AM

i would look at the "meat" or surface area for the gasket , i have bought some custom ones before but did not seal very out well and blow out

big_al_71 · 09-28-2013, 10:01 AM

Quality quality quality!!!!!!

same reason I paid $600.00 for billet hood hinges, march pulleys the list goes on and on.

I would not spend the kind of money I put in my truck if it was a rust bucket
When I do spend money I pay for the BEST nothing less do it one time and well done.

09-28-2013, 09:17 AM	#1
bigmac73 Senior Member Join Date: Mar 2012 Location: Chesapeake, Va Posts: 1,275	Re: Valve covers i would look at the "meat" or surface area for the gasket , i have bought some custom ones before but did not seal very out well and blow out __________________ Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks

09-28-2013, 10:01 AM	#2
big_al_71 Registered User Join Date: Jun 2008 Location: South Florida Posts: 11,375	Re: Valve covers Quality quality quality!!!!!! same reason I paid $600.00 for billet hood hinges, march pulleys the list goes on and on. I would not spend the kind of money I put in my truck if it was a rust bucket When I do spend money I pay for the BEST nothing less do it one time and well done. Attached Images __________________ Get your facts first, and then you can distort them as much as you please!!!!!. Sylvester's build thread >>>http://67-72chevytrucks.com/vboard/s...ht=big+rebuild



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.