(Another) New Guy 66C10 Stepside

[BCnNC]

Hello All,

Long time lurker, wanted to become "legit". The forum has been VERY helpful with my ride/projects. Invaluable guidance on the following mods;

CPP Disc Brake Conversion and front end rebuild (Note; Stock 15x6.5 rims do not work with the calipers, had to go with Summit Racing Rallys).
2.5" dropped spindles w/ 1" shorter springs, 4" dropped springs in the back.
Master Cyl with Vac Boost
Brake lines (Note: The T fitting on the back axle is special, so either save your old one, or buy a new one up front).
Carb Rebuild x3 (Roc B on a 250 L6) (Note; just go ahead and get the new gas tank, redo of the old one didn't work out so well)
HEI Ignition (thanks for the tip on the resistor wire - removal thereof).

Daughter getting married in Nov at a place called "The Dairy Barn" and she wanted to use my old truck as the getaway vehicle. It's been in storage for about 8 years. I think she was just doing me a favor as she knew I've been itching to get it back on the road (and I can hide some of the $ in the wedding budget)(ha).

Thanks again. Later.

[1963c-10]

welcome from Fayetteville NC. Nice looking short stepper you have there. Truck looks real good and nice to see its going to get used again.

[kieth]

Welcome, nice truck, get it going and drive it.......they are lots of fun. Kieth

[1963c-10]

Ohhh....and 73 and up stock GM steelies 4x4 rims will clear the calipers and allow you to run your factory hubcaps and trim rings.

[TJ's Chevy]

Nice truck! Welcome! Could we have some picture of that 572 big block with a turbo and 300 hp shot of nitrous?

[markeb01]

Beautiful truck! Welcome to the forum.

[WhippinSaw]

Great looking truck, love them stepsides. Perfect getaway vehicle for your daughters wedding. Had mine sitting for 21 years, forgot how much fun they are.

[Rich 5150 69]

sweet truck,,,!

[Ta2Don]

Very Nice, and I like the $ hiding idea...

[poorboy]

Nice truck! Welcome to the forum!

[Captainfab]

Welcome to the forum

That's a good looking truck