|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-14-2013, 06:34 PM
|
#16 |
|
Senior Member
 
Join Date: Nov 2008
Location: orangevale ca
Posts: 4,630
|
Re: Project TiC TaC cause it gonna be orange.....
If you are doing stainless. I recommend you get a mastercool flaring tool. Stainless is so hard to bend at 37 degrees with a hand tool. Your hands and fingers will be bleeding when you are done if you use a rotating hand tool. Check out the mastercool its the bomb.
|
|
|
| Bookmarks |
|
|
Threaded Mode