|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-07-2013, 11:05 AM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: Virginia
Posts: 233
|
Is this normal- Clutch linkage
Specifically where the mechanism pivots on the ball stud attached to the barcket attached to the block on the left.
|
|
|
|
11-07-2013, 11:15 AM
|
#2 |
|
Registered User
Join Date: Nov 2005
Location: Regina, Saskatchewan, Canada
Posts: 11
|
Re: Is this normal- Clutch linkage
Looks like it to me. Actually looks a bit bent in the picture. My V8 has a much stronger looking setup than that.
I don't have any pictures for you, but someone else may |
|
|
|
|
11-07-2013, 11:31 AM
|
#3 |
|
The Older Generation
   
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,432
|
Re: Is this normal- Clutch linkage
-
That's why it is a ball stud, so it will take up any differences in component position and engine movement. That looks like it may be a little excessive but bad engine or transmission rubber mounting pads could cause that. LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
|
|
|
11-07-2013, 04:12 PM
|
#4 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,505
|
Re: Is this normal- Clutch linkage
I agree with doc above, check your engine and trans mounts for excessive wear
|
|
|
|
|
11-11-2013, 02:50 AM
|
#5 |
|
Registered User
Join Date: Jul 2012
Location: Marysville, WA
Posts: 294
|
Re: Is this normal- Clutch linkage
Mine looks identical and I was going to post this same question. Replacement parts for the Z bar don't seem to be available. Mine is still working well, just don't like how it looks. Haven't had a chance to investigate though.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
