"its all about ol' black"

[doubleclucker]

Now onto my bellhousing I very simply took the factory sm465 bellhousing (the 85'-up hydraulic one ) fit it on the input bearing retainer of the nv4500(same size) set it straight and transfer punched the holes from the inside of the bellhousing to the face of the nv4500 drilled and tapped the face then bolted and wire locked it on ...done.
Keep in mind 95' and back nv4500 with external slave.
All bolts go outside of case if lined up correctly.
The bellhousing now has to be installed bolted on the transmission. (No problem went in easily with lots of room;Just like autos or nv5600 ,nv3500...)
Same clutch, release bearing ,pilot bearing ,fork and bell from the 4 speed I already had swapped to a 85'-up hydro bellhousing years before and had an extra one for this swap.
Forgot to mention the round pattern 86'-91 np205 has long 32 input I swapped out with the short 32 spline input from a 77'-84' bathtub np205. So no spacer is needed.