|
Re: 70 k5 front drive shaft
I think the are two inches difference in the later driveshafts. The springs are two
Inches longer in the front of later Blazers so it has To make up that space. If you have a lift then it might work to fill in the gap from the lift. Pretty sure the ujoints are the same 1310 joints though so it should bolt up. You could take it to a driveshaft shop and get it Cut to fit if need be. Just measure the space from yolk to yolk between the transfer case and front end and go to the junkyard and find one. I heard the new super duty ones fit but I've never measured to see for myself.
__________________
72 3/4 ton blazer. 5 inch lift on 35 inch tires. 355 corvette engine with crane roller rockers, rv cam, edelbrock carb and intake with one inch spacer. Thrush Headers with flowmaster 40 duels. 4speed sm465 manual. 4 wheel disk brakes with Inboarded rear shock prerunner style mounts and shocks.
|
01-15-2014, 06:29 PM
Threaded Mode