64-66 door weatherstrip-EUREKA!!!!

[markeb01]

Outstanding, thanks for sharing. It's a shame the aftermarket can't just make seals the same shape as the originals. I kept pieces of my originals and nothing in the aftermarket even comes close. Your discovery sounds like the answer for a lot of owners.

[Rob Fisher]

LV Photos
I measured the Accord Coupe and the Pilot and both are shorter then the Civic Coupe. If your picking them up from the wreckers you could always try to find a third one and piece it under the lower sill as 61K10 did.

[schpeen]

Originally Posted by Rob Fisher

LV Photos
I measured the Accord Coupe and the Pilot and both are shorter then the Civic Coupe. If your picking them up from the wreckers you could always try to find a third one and piece it under the lower sill as 61K10 did.

driver side arrived today so I installed it

perfect fit!

[Logans 66]

Thank you!!!

[gabbin]

How cool is that!

[49 cowboy]

Rob Fisher: I want to say a giant thanks to you. I have a 64 GMC and was having the same problem closing the doors until this morning when I put the Honda gaskets on mine and now my doors close fine. THANKS AGAIN!!!

[jb9281]

I bought the new chevy repop push on seals and I now have to slam my doors but I have less wind noise. My precision glue on seals I did not have to slam doors, but had a lot of wind noise. I think I will try a set of these Honda seals.

[likaroc13]

Originally Posted by jb9281

I bought the new chevy repop push on seals and I now have to slam my doors but I have less wind noise. My precision glue on seals I did not have to slam doors, but had a lot of wind noise. I think I will try a set of these Honda seals.

Who were your push-on seals made by?

[jb9281]

Made by Precision

[norcalcap]

For what its worth. I tried several different gaskets and the Honda gasket was the best fit for me. Left it in the sun for a bit and it snapped into place perfectly. I put the sharp corner in the lower front and it looks and fits great. The other gaskets made for this truck made my doors too difficult to close. The Honda rubber seemed a bit more collapsible. I did not trim the inner lip as it provides a buffer/pocket for my custom lower vent panels.

[dracko]

Originally Posted by norcalcap

For what its worth. I tried several different gaskets and the Honda gasket was the best fit for me. Left it in the sun for a bit and it snapped into place perfectly. I put the sharp corner in the lower front and it looks and fits great. The other gaskets made for this truck made my doors too difficult to close. The Honda rubber seemed a bit more collapsible. I did not trim the inner lip as it provides a buffer/pocket for my custom lower vent panels.

I agree, they collapse and let the doors close the best I’ve tried. Recently installed the Precision press on seals and they are nicely made but the Honda seals close easier. I don’t like that inner flap though, maybe because mine are from the auto wrecker they stick out more than new seals.

[Southcity]

Great write up and suggestion from user Rob Fisher, how about some pics and feedback from the users that have since posted here that they purchased a set?