Re: Homemade piston pin press
Quote:
Originally Posted by GRX
Nice idea. Thanks for sharing. I do this sort of thing for a living. Don't think I'd press against new pistons, especially cast hypereutectic types which are more brittle.
Wait .... heating the rod to install press fit wrist pins is standard procedure. Full floaters are just that. No press fit. They have a bushing in the rod for specific clearance so the pin can move freely. That's why they're floaters. A groove in the piston along with retaining clips keep the wrist pin in place.
|
Oops, I had two ideas in my head... one for floating and one for pressed and then I typed the wrong one. I would never actually use this to press pistons on either becausr the heat method is so much easier.
__________________
- 1981 Sierra 454, NV4500 swap
- 2006 Z06, 25k miles
- 1973 Nova - Project CarNova Virus on Youtube
|