Floor pan question? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

familyfast64 · 04-28-2014, 09:28 PM

I just replaced my body bushings and noticed the holes through the frame had been wallowed out on one side. Most likely the result of your same problem. Can you check your frame and make sure it's close?

BigSix · 04-28-2014, 09:47 PM

Quote:

Originally Posted by familyfast64

I just replaced my body bushings and noticed the holes through the frame had been wallowed out on one side. Most likely the result of your same problem. Can you check your frame and make sure it's close?

Slightly off topic but did you have to remove the tank when you did the back two body mounts?

racecougar · 04-29-2014, 08:12 AM

Quote:

Originally Posted by familyfast64

I just replaced my body bushings and noticed the holes through the frame had been wallowed out on one side. Most likely the result of your same problem. Can you check your frame and make sure it's close?

Who is this question directed to?

04-28-2014, 09:28 PM	#1
familyfast64 Registered User Join Date: Sep 2013 Location: Cheney, Kansas Posts: 337	Re: Floor pan question? I just replaced my body bushings and noticed the holes through the frame had been wallowed out on one side. Most likely the result of your same problem. Can you check your frame and make sure it's close? __________________ Live and let live



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.