NC 305 HO 601 heads stainless steel valves

[qksilver]

I have a set of 601 53 cc combustion chamber heads with stainless steel valves, up graded springs and a full on 3 angle valve job.

These heads were magnafluxed, hot tanked, surfaced , all valves replaced with stainless steel valves, new keepers and retainers, 500 lift valve springs, new valve guides and seals.

Good for torque engine builds when you want to keep the compression in a good range for pump gas, or for smaller engine builds to maintain compression
and good power or for circle track when limited to factory steel heads.

I had them on a 327 for a while when they were stock, good torque and no problems with burnt exhaust valves, as the set I replaced them for. Then I went thru them completely and has them on a 283 with 3x2 in my 57 1/2, they also did great. Around 2000 miles, didn't drive the truck very much because of stock steering and brakes

$200.00 plus shipping

drop shipped from 28387 and i will have the weight tomorrow so you can figure out an approximate shipping quote .

Thanks,
Steve

[DPowers]

Interested- depending on shipping.

[qksilver]

I did a quick quote and it was 54.50

Steve

[DPowers]

Good deal and would bolt on my 283, but will have to pass for now.

[qksilver]

nice set of heads.clean up the surfaces and bolt them on, great for torque and the street.


steve

[zicc1835]

Could you check shipping to 07981
Thanks
Jz

[qksilver]

about $55 let me know with an address to give you an exact quote

Thanks,
Steve

[Leroy-B1]

Shipping to 28787 or do you come to the west end of state any?

[zicc1835]

Originally Posted by qksilver

about $55 let me know with an address to give you an exact quote

Thanks,
Steve

P M sent

[qksilver]

ZICC looking at $250 total paid with a USPS money order, I rounded it down 4 bucks


Leroy not sure why so much, a quick quote came up 69 72 , I don't go west much sometimes charlotte to buy parts but never know when, depends on Craigs list. You are about 250 miles from me


Thanks,
Steve

[zicc1835]

Originally Posted by qksilver

ZICC looking at $250 total paid with a USPS money order, I rounded it down 4 bucks


Leroy not sure why so much, a quick quote came up 69 72 , I don't go west much sometimes charlotte to buy parts but never know when, depends on Craigs list. You are about 250 miles from me


Thanks,
Steve

Ill take them sending u a p m
Jess

[qksilver]

sold pending payment

Thanks,
Steve

[qksilver]

paid for and shipped

[zicc1835]

Originally Posted by qksilver

paid for and shipped

and.... delivered...... packaged nicely and quick deliv thanks much