ignition switch bezel.. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

lotik · 01-08-2004, 12:57 AM

how does it go in the dash, i had bought a new one but it didnt fit in the hole. it was to small. but i dont see how it would work if it was bigger anyways. how does it catch on the inside of the dash? its a 72 dash. thanks

jorgensensc · 01-08-2004, 01:40 AM

Thereis a special switch retaining nut you also need. they cost 5.00 from the truck shop in orange , ca. (1-800-243-8947)
Part number 68-04706
Or you can rig it with a bearing shell and a nut like I did(until I get one)
Check thier website catalog.
Hope this helps!!

01-08-2004, 12:57 AM	#1
lotik drag it like you stole it Join Date: Feb 2002 Location: Louisiana Posts: 542	ignition switch bezel.. how does it go in the dash, i had bought a new one but it didnt fit in the hole. it was to small. but i dont see how it would work if it was bigger anyways. how does it catch on the inside of the dash? its a 72 dash. thanks __________________ negative camber //LA\\

01-08-2004, 01:40 AM	#2
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,005	Thereis a special switch retaining nut you also need. they cost 5.00 from the truck shop in orange , ca. (1-800-243-8947) Part number 68-04706 Or you can rig it with a bearing shell and a nut like I did(until I get one) Check thier website catalog. Hope this helps!! __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.