|
06-06-2014, 10:59 AM
|
#1 |
|
Registered User
Join Date: Mar 2013
Location: Grand Island, Ne.
Posts: 1,110
|
2 piece drive shaft
Heya guys,
I'm trying to figure out where to get a 2 piece drice shaft for my 72 C10 SWB I have a single but since I'm putting the truck on the ground, (PB Extreme) I am under the impression that I have to run the 2 piece. Any help would be nice. Thanks guys.
__________________
J. Vess, 6'6", Gearhead, Welder, Fabricator, Nutcase 1955 Chevy Stepside "Dudley" My daily http://www.67-72chevytrucks.com/vboa...d.php?t=760288 1972 Chevy C10, Project "Chevro~Layed out" Nether Storm Build Thread http://67-72chevytrucks.com/vboard/s...23#post6007523 |
|
|
|
06-06-2014, 11:30 AM
|
#2 |
|
Registered User
Join Date: Aug 2013
Location: la puente ca
Posts: 358
|
Re: 2 piece drive shaft
Does it need to be brand new?Can you find a used drive shaft locally?if you get a 2 piece from a longbed you can have have it cut down and rebalanced.That's what i did kinda...
Only the front drive shaft will need to be shortened.The rear is the same for longbed and shortbeds.  
|
|
|
|
|
06-06-2014, 02:54 PM
|
#3 |
|
Registered User
 Join Date: Dec 2013
Location: Dunwoody,Ga
Posts: 443
|
Re: 2 piece drive shaft
I had a 2 piece in my swb 70 and after replacing rubber donut or bearing every couple years my truck mechanic put in a one piece - problems gone. Make your you need e piece.
|
|
|
|
|
06-06-2014, 04:44 PM
|
#4 |
|
Registered User
Join Date: Mar 2013
Location: Grand Island, Ne.
Posts: 1,110
|
Re: 2 piece drive shaft
lolife said I did, and I believe him due to the fact he has built a ton of these lowered trucks. I guess I just need to hit the junk yards around here. Thanks for the help.
__________________
J. Vess, 6'6", Gearhead, Welder, Fabricator, Nutcase 1955 Chevy Stepside "Dudley" My daily http://www.67-72chevytrucks.com/vboa...d.php?t=760288 1972 Chevy C10, Project "Chevro~Layed out" Nether Storm Build Thread http://67-72chevytrucks.com/vboard/s...23#post6007523 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
