|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-29-2014, 11:46 PM
|
#1 |
|
Registered User
Join Date: Mar 2014
Location: Clackamas OR
Posts: 20
|
HELP with valve cover breathers
So i picked up some nice, older edelbrock valve covers for my father in laws truck. I had them roto-blasted and looking nice again. I went to install them today and bought new breathers and noticed they came with new gaskets so I removed the old ones.....
The issue is that the new breather and gaskets are too large. I found new 3/4in breathers but all the gaskets I found to go with them are for 1-1/4" holes and mine are smaller. What should I do? |
|
|
|
06-30-2014, 12:38 AM
|
#2 |
|
Registered User
Join Date: Feb 2011
Location: Modesto, CA
Posts: 2,186
|
Re: HELP with valve cover breathers
I'm not a fan of the help! section in most auto parts stores, but they do in fact help in some occasions. I'm pretty sure I had luck finding smaller diameter valve cover grommets there. What brand breathers did you get that are 3/4, and where did you get them?
|
|
|
|
|
06-30-2014, 08:48 AM
|
#3 |
|
Registered User
Join Date: Jun 2010
Location: Upland Ca
Posts: 4,143
|
Re: HELP with valve cover breathers
Both Jegs & Summit offer breather grommets in different sizes.
__________________
1972 C10 SWB, Air, PS, PB, 350/350THM. Second owner. 1965 Corvette roadster, 44K miles, 327/365 SHP, 4 speed, side exhaust, knockoffs, teak, second owner (bought in 1970), Have ALL numbers matching components. My frame off restoration thread: http://67-72chevytrucks.com/vboard/s...d.php?t=556703 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
